

Recovery and Reuse
END OF LIFE SOLUTIONS
In electrical distribution markets, SF6 is forbidden to be used in new products. But SF6 was in use for the last +30 years. These units have a life of 30 years. So they are end of their service life. Now there are devices to be replaced or scrapped due to end of life.

Possible to connect all types of products
Equipment is mobile so operation can be done anywhere onsite
Gas vacuumed down to 1 mbar in any type of casing.
Gas is analyzed with NDIR testing device to check purity level.
EOL product can be highly toxic and corrosive.
The inside of the device is washed with basic solutions to neutralize.
Controlled with Ph meter.
At this stage the EOL product is cleaned , gas is analyzed and recovered then steps 4, 5, 6 are to be operated
-
Based on purity level, the Product with the lowest contamination is filtered and purified.
-
The final product is pure SF6 IEC 60376 and stored aside or supplied back to the product
-
If gas is very polluted gas is incinerated. heavily arced gas will be settled to Soda and Toothpaste material
Components of Recovery as Kıts
Gas Recovery Cart
Perform recovery operation down to 1 mbar.
Even in conditions where tank does not support dilution process is performed to recover down to 1 mbar.
the recovered gas is stored in liquid state to save space..
Leak rate is down to 1 e-5 mbarl/s
Gas Purification Cart
Gas analysis kit analyzes the existing gas composition.
In case of low contamination, gas can be filtered and regenerated automatically.
Air is removed through the cooling of the mixture.
Then the gas obtained can be sent back to system again
Mobile Gas Incineration Device
Gas is collected through recovery kit
If the gas is extremely polluted then it can be incinerate through this device